Cognex In-Sight 7000 Gen2 Série Manuel D'utilisation page 15

Install the Converter Mounting Bracket
(ISB-7000-7K)
Complete the following steps to attach the converter accessory mounting bracket
(ISB-7000-7K) to the vision system.
Note: When attaching the vision system to the mounting bracket, use the M3
screws supplied with the mounting kit. If using the 1/4 - 20 or M6 screw holes,
the thread length of the screw should not exceed 7mm.
CAUTION: The vision system should be grounded, either by mounting the
vision system to a fixture that is electrically grounded or by attaching a wire
from the vision system's mounting fixture to frame ground or Earth ground. If a
ground wire is used, it should be attached to one of the four mounting points on
the back plate of the vision system and not to the mounting points on the front
of the vision system.
1. Align the converter mounting bracket with the mounting holes on the vision
system.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex
wrench. The maximum torque is 0.90 Nm (8 in-lb).
14