Programming - AUtec E16 Série Mode D'emploi

!
The dip switches must be programmed with the battery removed
from the transmitting unit and can be done only by authorised per-
sonnel.
The incorrect closure of the transmitting unit and the receiving unit
can compromise the seal between the casings and thereby the grade
of protection from dust and water.
For the correct functioning, the group of 8 dip switches (excluding
DIP 1) for the radio modules E16STXEU_ (transmitting unit) and
E16SRXEU_ (receiving unit) must be set in the same way.
RADIO TRANSMITTING MODULE E16STXEU_ DIP SWITCHES
The group of eight dip switches lo-
cated in the radio modules are
used to program some operations
and set the working frequency.
The programming set in the other
group of four dip switches must
never be modified.
DIP MODULE STATE
1 E16STXEU_
2 (*) E16STXEU_
E16STXEU1
3
E16STXEU2
3-7 E16STXEU_ ON/OFF
8 E16STXEU_
(*) For the SIRIO 42 transmitting unit the dip switch must be at ON: consult the technical
sheet for any activation/deactivation of the flat battery warning.
Page 30 of 80

8 PROGRAMMING

Group of 8 dip switches
ON The transmitting unit never switches off automatically
The transmitting unit switched on without movement com-
OFF
mands entered switches off after approx. 3,5 minutes
ON Deactivation of low battery warning from horn on machine
OFF Activation of low battery warning from horn on machine
If DIP 8 is OFF automatic scan of the frequencies in the
ON
If DIP 8 is OFF automatic scan of the frequencies in the
OFF
ON
If DIP 8 is OFF automatic scan of the frequencies in the
OFF
If DIP 8 in ON see "Appendix: Frequency Table"
Manual selection mode of the frequencies using DIP 3 -
ON
DIP 7 (refer to Appendix: FREQUENCY TABLE)
Automatic scan mode of the frequencies in the band
OFF
selected by DIP 3 (DIP 4 - DIP 7 indifferent)
8 - Programming
Group of 8
dip switches
Group of 4 dip
switches
FUNCTION
band 433.050 - 434.040
band 434.050 - 434.790
DO NOT USE
band 869.700 - 870.000
LIESNMU4