Transmitting Unit Diagnostic - AUtec E16 Série Mode D'emploi

9 TRANSMITTING UNIT DIAGNOSTIC

If the "machine+radio remote control" system does not start, check if the problem is caused
by the radio remote control or the machine. Before carrying out any verifications, check the
functioning of the machine with the cable control panel:
- if it does not switch on, the problem lies with the machine itself
- if it does switch on, the problem lies with the radio remote control. In this case, do the fol-
lowing:
When START is
activated, is the
LED on steadily (*)
and does the
buzzer sound?
NO
Is the led blinking
fast (*)and the
buzzer sounding?
NO
Is the LED
blinking slowly?
NO
If the problem per-
sists
CALL SERVICE
(*) Green or red LED.
LIESNMU4
Is the STOP
pushbutton or one
YES
of the movement
actuator inserted?
Release it/them
The battery is dis-
charged: replace it with
YES
one that is charged.
Does it continue to
blink quickly and the
buzzer sounding?
NO
Carry out
YES
diagnostics checks
on the receiving
unit.
9 - Transmitting unit diagnostic
Is the led on with a
steady light?
NO
Clean the battery
contacts. Does it
YES
continue to blink
quickly and the
buzzer sounding?
NO
YES
YES
Page 31 of 80