Programming - AUtec Modular Série Manuel De L'utilisateur

!
The dip switches must be programmed with the battery removed
from the transmitting unit and can be done only by authorised per-
sonnel.
DIP SWITCHES ON E16STXEU_ RADIO TRANSMITTING UNIT
The group of eight dip switches
found in the module is necessary
for programming some opera-
tions and setting the operating
frequency.
The programming set in the oth-
er group of four dip switches
must never be modified.
DIP MODULE
1 E16STXEU_
2 E16STXEU_
E16STXEU1
3
E16STXEU2
8 E16STXEU_
!
These eight dip switches must be programmed in the same manner
as the group of 8 dip switches (excluding DIP 1) present in the radio
module of the receiving unit (see manual).
Page 26 of 71

8 PROGRAMMING

Group of 8 dip switches
POS.
ON The transmitting unit never switches off automatically
The transmitting unit switched on without movement
OFF commands entered switches off after approx. 3 and half
Deactivated of low battery warning from horn on
ON
OFF Activation of low battery warning from horn on machine
Automatic scan mode of the frequencies in the
ON
Automatic scan mode of the frequencies in the
OFF
ON
Automatic scan mode of the frequencies in the
OFF
Manual selection of frequencies
ON
(DIP 3 - DIP 7 see "FREQUENCY TABLE" on page 71)
Automatic selection and scanning of frequencies
OFF
8 - Programming
Group of 8
dip switches
Group of 4 dip
switches
DESCRIPTION
minutes
machine.
433.050 - 434.040 MHz
434.050 - 434.790 MHz
DON'T USE
869.700 - 870.000 MHz
(DIP 3 - DIP 7 OFF)
LIMJNMU0