AUtec E16 Série Mode D'emploi page 23

!
It should be remembered that in some countries rules must be respected
that control:
- the use and/or possession of a radio remote control;
- the use of operational frequencies which have not yet been harmonised
in Europe.
All the indications that must be observed can be found in the "Limita-
tions & Authorisations" document, which is included in the product's
documentation.
As required by the Machines Directive and relative harmonised standards, all ma-
chines must undergo a risk analysis; therefore it is necessary to evaluate, within the
limits of this analysis, if the machine can be radio remote controlled.
The machine producer and/or the person who decides upon radio remote control use
and installation is responsible for this analysis.
Autec cannot be held responsible if the risk analysis is not carried out correctly.
To guarantee correct radio remote control operation, all current regulations regarding
safety at work and accident prevention must be respected. All current user country na-
tional laws regarding the use of both the machine and the radio remote control MUST
ALWAYS be respected.
Autec cannot be held responsible if the radio remote control is used in unlawful
working conditions.
!
In case of malfunctions and/or damaged and/or faulty parts, PUT the
radio remote control out of use until the problem has been complete-
ly eliminated.
Any damaged parts can ONLY be replaced by authorised Autec person-
nel, and only using original Autec spare parts.
INSTRUCTIONS FOR DOCUMENT MANAGEMENT
The following minimum documentation is supplied with each radio remote control:
- transmitting unit manual
- receiving unit manual
- battery charger manual
- EC conformity declaration
- certificate of guarantee
- radio remote control technical data sheet
- enclosed "Limitations & Authorisations".
Make sure that the following documents have been supplied: if they are not,
please ask them to Autec specifying the product serial number.
LIESNMU4
LIMITATIONS & AUTHORISATIONS
2 - E16 series introduction Page 19 of 80