Publicité
Les langues disponibles
Les langues disponibles
significantly
worn out.
• Appliance
placed too
weakly.
Appliance
• O-ring is
running too
damaged.
slowly
• Valve is
damaged.
Firing
• Wrong nails
mechanism is
used.
blocked by nails
• Firing
mechanism has
fray.
Appliance not
• Check the air
working
inlet. Operating
pressure may
be too low.
Air leaking from
• Tighten the screws or install the
the appliance in
absorber or a set of pins.
the bottom part
Wrong reverse
• Clean the appliance and install an
movement
absorber or a set of pins.
Other failures
• Contact an expert, seller or
distributor.
Clamps/nails
• Magazine dirty
blocked in the
• Belt with
guide plate
clamps/nails
not moving fully
forward
• Ram worn-out
Maintenance table
Following the maintenance instructions specified in
this document will provide this high-quality product
with long and trouble-free operation. Disconnect the
appliance from the compressed air source for
maintenance and treatment. To ensure long and
trouble-free working of your tacker/nailer, it is
necessary to clean it every day and regularly lubricate
it. For this purpose, special tool oil should only be
used:
Via oil mist
A complete maintenance unit includes
lubricator
an oil mist lubricator and is fitted on
the compressor.
Via lubricator on
In the immediate vicinity of the
the piping
appliance (app. 50 cm distance), a
lubricator sufficiently providing the
appliance with oil is installed on the
lubricator piping.
Manually
If your appliance has no maintenance
unit or lubricator on piping, 3-5 oil
drops must be added to the
compressed air connection before the
pneumatic appliance is put into
operation. If the pneumatic appliance
has been out of service for several
days, 5-10 oil drops must be added to
the compressed air connection before
switching the appliance on. Store your
pneumatic appliances only in dry
rooms.
mechanism.
• Place the
appliance
stronger.
• Replace the O-
ring.
• Replace the
valve
completely.
• Insert correctly
appropriate
nails.
• Remove the
firing
mechanism off
fray.
• Increase the
operating
pressure.
However, max.
operating
pressure must
be adhered to.
• Clean (blow) the
magazine.
Wrong
clamps/nails
have been used.
Use appropriate
clamps/nails
Lubricate the appliance with special oil for pneumatic
appliances using an extension if there has been a long
operation break.
Store the appliance in a cleaned, dry, dust-free condition
and at temperatures above 5° C.
Publicité
