Zhermack SAND S23 Mode D'emploi page 131

MAINTENANCE AND USE MANUAL
The equipment exterior can normally be kept clean just by wiping it with a dry cloth. If necessary, wet
the cloth just a little water or use a non-degreasing detergent. The operator must ensure that the
equipment is kept clean and free from any foreign bodies such as dirt, water, non-conducting liquids
etc. The equipment must be cleaned at the end of every work session to remove all residues. Cleaning
must be done with the equipment at standstill and positioned in a stable manner.
Before cleaning the equipment exterior always turn the main switch to OFF. It is
strictly forbidden to clean the equipment while it is connected to the mains power
supply.
Never use inflammable, corrosive, alkaline or toxic liquids when cleaning the equipment.
Eye goggles and a face mask must be worn when using compressed air for cleaning
purposes. Do not allow any persons near the equipment as they could be hit by flying
dust.
Carry out the cleaning tasks described below with extreme caution. Bear in mind the
weight and size of the equipment (see Section 4.2.3) and, if necessary, carry out the
following tasks with the aid of another worker.
For optimum cleaning of the sandblasting equipment use of the SAB 1000 aspirator produced by
Zhermack is recommended.
Nevertheless, to empty the residual sand from the sandblasting equipments proceed as follows:
• bring the sandblasting equipment to the edge of the worktop until the plug on the bottom of the
sandblasting chamber (SAND S24R - S25R) or on the left (SAND S23 - S24 - S25) is protruding.
• Then position a recipient under this aperture, remove the internal mesh and the plug.
Elimination and/or recycling of the used sands (and, consequently, sandblasting
process residues) must be carried out in compliance with EC directives or
according to the laws in force in the country of use.
If the SAND sandblasting equipment is not to be used for a lengthy period of time it is recommended
that the equipment be disconnected from the electrical power supply so as to prevent overheating of
the equipment and/or any connected aspirator.
SAND S 23 / S 24 / S 24 R / S 25 / S 25 R
EN
CHAPTER 8: MAINTENANCE
Cleaning the inside of the sandblasting equipment
CLEANING
8.1
8.1.1
131 of 176