Dishwasher Care - Maytag MDB8989SHK Guide D'utilisation

Delay
Runs dishwasher at a later time or during off-peak
Hours electrical hours. Select a wash cycle and options.
Press DELAY button to delay the cycle by 8 hours.
Press START. Close door firmly.
NOTE: Any time the door is opened (such as, to
add a dish), the START keypad must be touched
again to resume the delay countdown.
CONTROL PURPOSE
Press to START a
START
wash cycle
CANCEL
Press to CANCEL
wash cycle
hold 3 sec
Cleaning the Exterior
Clean the exterior of the dishwasher with only a soft, damp cloth,
and mild detergent. If your dishwasher has a stainless steel
exterior, it may have a coating that is resistant to fingerprints.
Avoid using abrasive cleaning products on the exterior of the
dishwasher.
Cleaning and Maintaining the Interior
Many detergents may leave white spots or a white residue on
dishware and on the interior of the dishwasher. Over time this
residue can become unsightly and could affect dishwasher
performance. Use of a dishwasher cleaning product such as
affresh ® † Dishwasher Cleaner can help to remove the residue.
Monthly use of affresh † Dishwasher Cleaner is recommended
®
to help maintain the dishwasher. Follow package directions.
NOTE: Maytag recommends the use of high-quality,
premeasured detergent tablets or packs and the use of rinse aid
for dishwasher cleaning and daily care.
†affresh is a registered trademark of Whirlpool U.S.A.
®
First try the solutions suggested here. If you need further assistance or more recommendations that may help you to avoid a service
call, refer to the warranty page in this manual or visit https://www.maytag.com/product_help.
In Canada, visit http://www.maytag.ca
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Maytag Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
If you experience
Dishwasher does It is normal for certain cycles to repeatedly pause for several seconds during the main wash.
not run or stops Is the door closed tightly and latched?
during a cycle
Is the right cycle selected?
Is there power to the dishwasher? Has a household fuse blown, or has a circuit breaker tripped? Replace the
fuse or reset the circuit breaker. If the problem continues, call an electrician.
Has the motor stopped due to an overload? The motor automatically resets itself within a few minutes. If it
does not restart, call for service.
Is the water shutoff valve (if installed) turned on?
OPTIONS
If the door is opened during a cycle or the power is interrupted, the START button LED
flashes. Cycle will not resume until START is pressed and the door is closed. Push door firmly
closed within 4 seconds of pressing START.
Press and hold CANCEL for 3 seconds. Close the door firmly. The dishwasher starts
a 2-minute drain (if needed). Let dishwasher drain completely.

DISHWASHER CARE

TROUBLESHOOTING
Recommended Solutions
CAN BE WHAT IT DOES
SELECTED
WITH
Available
Delays start of a
with any cycle by 8 hours.
cycle
COMMENTS
If you have a drain air gap, check
and clean it if the dishwasher
isn't draining well.
To Reduce Risk of Property Damage During Vacation or
Extended Time Without Use
When you will not be using the dishwasher during the
■
summer months, turn off the water and power supply to the
dishwasher.
Make sure the water supply lines are protected against
■
freezing conditions. Ice formations in the supply lines
can increase water pressure and cause damage to your
dishwasher or home. Damage from freezing is not covered
by the warranty.
When storing your dishwasher in the winter, avoid water
■
damage by having your dishwasher winterized by authorized
service personnel.
In Canada:
Maytag Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
ADDED ADDED
TIME TO WATER
CYCLE GALLONS
(LITERS)