Meec tools 071015 Mode D'emploi page 38

EN
TROUBLESHOOTING
Problem
Air leakage near the top of the
tool or at the trigger.
The tool does not work or
operates sluggishly.
Air leaking at the bottom of
the tool.
Nails often jam in the tool.
38
Possible cause
Loose screw connections.
O-ring or seal is worn or
damaged.
Low air pressure.
Inadequate lubrication.
O-rings or seal are worn or
damaged.
Loose screw connections.
O-rings or seal are worn or
damaged.
Incorrect fasteners loaded.
Damaged fasteners.
Magazine or nose screws loose. Tighten screw connections.
Magazine is dirty.
Driver is worn or damaged.
Proposed action
Tighten screw connections.
Replace damaged or worn
parts.
Check that the air pressure
supply is correct.
Put 5–6 drops of oil into the
air inlet.
Install TOP maintenance kit.
Tighten screw connections.
Replace damaged or worn
parts.
Use approved fasteners of
correct size.
Replace with undamaged
fasteners.
Clean the magazine.
Replace damaged or worn
parts.