Service And Repairs - Meec tools 071015 Mode D'emploi

working order. There must be no loose,
missing or jamming parts.
• Always keep screw connections tight.
Loose screw connections can result in
personal injury, or damage to the tool.
• If the tool is operated without a lubricator,
add 5–6 drops of compressed air oil into
the air inlet of the tool at the start of each
working day.

SERVICE AND REPAIRS

All quality tools eventually need servicing and
replacement of parts due to normal wear and
tear. See the TROUBLESHOOTING section for
information about parts that can be serviced by
the user. All repairs that are carried out by local
agencies are fully guaranteed against defective
material and workmanship. The warranty does
not cover repairs carried out by anyone other
than these agencies.
TROUBLESHOOTING
See table on next page.
EN
37