Inspection And Maintenance Plan - Güde Big Wheeler 508 VARI-S Traduction Du Mode D'emploi D'origine

ENGLISH
32

Inspection and maintenance plan

Regular servicing period
Engine oil Inspection
(10W-40)
Change
Air filter Inspection
Change
Spark plug Inspection
Clean
Change
battery Inspection
Charging
before winterising, disconnect the spark plug cable from the battery and reconnect it before
putting the appliance into operation again.
Provide appropriate servicing upon the earlier of the following: in the given month or after the specified hours of
operation have expired.
Defects searching
Defect
The motor does not start
Grass is not collected
Automatic feed is not
working
Before
any start-
up


22
Causes
Start-Stop lever has not been pressed
Primary pump has not been used
Lack of fuel
bowden cables are too long
Wrong fuel, storing without petrol tank
being drained
Sooted spark plug (carbon residues on
electrodes), electrodes distance too big
The spark plug is wet from petrol
(oversaturated engine).
blocked channel
Full collection bag
Too wet grass
bowden cables are too long
After 1 After 3
month months
5 25 Hours
Hours of of opera-
operation tion

measure
Press the Start-Stop lever
Use the primary pump
Add some fuel
Adjust the bowden cables using the
coupling nut.
Drain the fuel tank and carburettor.
Add fresh petrol.
Clean the spark plug, check the plug ther-
mal value, possibly change the plug, set
the electrodes distance to 0.6-0.7 mm
Dry the spark plug out and refit it.
Clean the ejection channel
Empty the collection bag
Cut in dry weather
Adjust the bowden cables using the
coupling nut.
After 6 After 12
months months
50 Hours 100 Hours 250 Hours
of opera- of opera-
tion tion





After 24
months
of opera-
tion
