Maintenance And Cleaning - FALMEC Diamante 90 Livret D'instructions

above. The two filters located at the ends of the motor can now be easily accessed.
To install the new fi lters see picture.
In case of hood with the motor box the fi lter is located on the botton part of the motor box.
To install the new fi lters see picture.
To order new charcoal fi lters contact the distributor/retailer.
VALID ONLY FOR ITALY: download the appropriate order form from: www.falmec.com (access
the assistance drop-down menu).
I
LIGHTING
1. FLUORESCENT TUBE (DIAMANTE)
Fluorescent tube replacement:
a) Disconnect the appliance from the mains.
b) Remove the steel panel and the metal filters (see H 1). Undo the 2+2 knurled fixing studs
in the steel support.
c) Remove the neon tube by rotating it by 90° and replace it with an identical one (13W tube
T5).
d) Repeat point B in reverse.
e) Reconnect the appliance to the mains
2. LED SPOTLIGHT (GLEAM)
In this case the hood is equipped with high efficiency, low power LED spotlights with ex-
tremely high durability under normal use conditions. LED spotlight replacement should only
be carried out by qualified technicians using only original spare parts.
L

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air
ASSEMBLY AND REPLACEMENT