Bose Professional DesignMax DM2S Notice D'installation page 5

PRO.BOSE.COM
Using a Safety Cable
Some regional construction codes require the use of a secondary
method of securing loudspeakers to support structures
to provide additional safety. Choose a mounting position,
method, and hardware consistent with local building codes and
regulations.
A safety cable can be attached to the loudspeaker using the
threaded insert on the back of the enclosure.
The insert is sized for an M6 screw (not included).
Loudspeaker Orientation
Choose the loudspeaker orientation best suited for your
installation.
q
Horizontal
w
Vertical
Note: Installation in close proximity to cooking surfaces where the loudspeaker may be directly exposed to cooking oils, such as in
commercial cooking environments, may decrease the performance or functionality of the loudspeaker.
Installing the Bracket
Note: When choosing an installation location, at least one of the mounting bracket's attachment points must be secured to a support
structure. Attachment points not secured to a support structure must be secured using appropriate hardware for the installation.
1. Mark the drill holes.
2. Drill two holes (sized for appropriate fasteners) into the wall.
3. Secure the bracket to the wall with two screws (not included). Note: Use M5 or #10 sized screws.
q
Wiring the Connector
1. Feed the wires through the center hole of the bracket.
2. Remove the connector from the loudspeaker.
3. Wire the connector. For wiring information, see Wiring the
Loudspeaker on page 4.
Installation Guide • DesignMax DM2S
q
w
q
Installation
w
e
English • 5