Acoustic Signals; Options - Electrolux ESL5310LO Notice D'utilisation

10 www.electrolux.com
How to deactivate the rinse aid
empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
and the display is blank.
2. Press
• The indicators
go off.
• The indicator
flash.
• The display shows the current
setting.
–
–
3. Press
4. Press the on/off button to confirm the
setting.

6.4 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.

7. OPTIONS

Desired options must be
activated every time before
you start a programme.
It is not possible to activate
or deactivate options while a
programme is running.
Not all options are
compatible with each other.
If you have selected non
compatible options, the
appliance will automatically
deactivate one or more of
them. Only the indicators of
the options still active will
stay on.
until the indicators
and start to flash
.
and
continues to
= rinse aid empty
notification activated.
= rinse aid empty
notification deactivated.
to change the setting.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
How to activate the acoustic
and
signal for the end of
,
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
and the display is blank.
2. Press
• The indicators
• The indicator
• The display shows the current
3. Press
setting.
4. Press the on/off button to confirm the
setting.
7.1 XtraDry
Activate this option when you want to
boost the drying performance. With the
use of this option, the duration of some
programmes, water consumption and the
last rinse temperature can be affected.
The option XtraDry is not a permanent
option and must be selected at every
cycle.
How to activate XtraDry
Press and hold simultaneously
until the indicator
until the indicators
and
.
and
off.
continues to flash.
setting:
– = Acoustic signal off.
– = Acoustic signal on.
to change the
comes on.
and
,
start to flash
go
and