Doro Secure 347 Mode D'emploi page 18

Speed dial (Alarm numbers)
The telephone has 4 speed dial numbers (M1-M4). When a
telephone number has been stored it can be dialled by pressing
just one button.
A picture or symbol can be placed under the transparent cover
on the speed dial buttons so it is easy to see who you are calling.
Storing Speed Dial Numbers
1. Press .
P
2. Enter the phone number (up to 22 digits) using the keypad.
Press .
P
3. Select speed dial number (M1-M4) by pressing the
corresponding button.
Press if you want a break in the telephone number.
r
If you need to change a number, store the new number in the
same location as the old one.
If no number has been stored for the speed dial
numbers (M1-M4) the telephone will flash alternately
green and red until this has been done.
Making an alarm call with speed dial
1. The alarm is activated manually by pressing the
the telephone or the cordless alarm unit. The button should be
pressed down for about 2 seconds until the telephone begins
to beep and the light comes on. (It is also possible to link to a
cord-connected alarm unit, see External alarm unit).
2. If you wish to terminate the alarm, hold down STOP
the button on the cordless alarm unit for approx. 4 seconds
until the phone stops beeping and the light switches off.
It is also possible to interrupt an alarm by lifting the handset.
Dialling speed dial with the handset
1. Lift the handset and wait for the dialling tone.
2. Press the desired speed dial button.
English
7
button on
or
g