Installation Of The Product; Installation - Bodet Harmonys 607725 I Notice D'utilisation

II - Installation of the product

2.1 Installation

1/ Select the location where the controller will be installed according the presence of the network
cable and a 110-230VAC +10%, 50/60 Hz. The location of the loudspeaker is to chosen
according to the proximity of the controller.
2/ Install the Harmonys outdoor sounder controller:
- Open the controller by loosening the 4 screws with a flat screwdriver.
- Remove the lid of the controller.
- Drill the holes predefined.
- Mount the controller in its location using 4 screws.
3/ Install the loudspeaker(s) in its (their) location(s) which must be within 5 meters of the
controller (length of the audio cable supplied by Bodet). This length can be extended to a
maximum of 40 meters.
Make sure that it is tightly fitted against its mounting surface to prevent any vibrations.
4/ Connect the audio line (40 m maximum with cable 2x0.75²) between the loud speaker and the
controller.
5/ Connect the Ethernet network cable to the RJ45 connector.
Ethernet cable category: 5 minimum or 6.
The broadcast mode will have to be selected in the Network configuration page of the
embedded web server (see page 17), in Multicast mode the address of the product must be the
same as that of the server (by default 239.192.55.1).
Record the MAC address (identification label on the back of the product) of the product, it will be
useful during its detection by the Sigma sofftware in order to rename it.
250
16
97,5
195
140
194