What To Do If - Bodet Harmonys 607725 I Notice D'utilisation

IV - What to do if...? ... Check.

What to do if...?

No broadcasting sounders
No DHCP server on the
network
Harmonys does not
broadcast any sound
24
1) The multicast address is identical between the master clock
and Harmonys.
2) Network parameters are supported: Harmonys must be on
the same Ethernet network as the computer with the Sigma
software.
1) By default the Harmonys takes on the following IP setting
(after 3min):
- IP: 192.192.223.100 (1st sounder), 192.192.222.101 (2nd
sounder), etc.
- MASK: 255.255.0.0
- Gateway: 0.0.0.0
- DNS: 0.0.0.0
(After 15 minutes, the sounder asks an address DHCP server).
2) Using the Sigma software (Configuration> IP devices>
Network button) to set the network settings Harmonys (product
identification with the MAC address on the tag on the back of
the product).
1) the length of the cable is lower than 100 meters (refer to the
standards of network cabling).
2) Harmonys is on the broadcast area of the master clock Sigma.
3) The sounder volume is high enough in the programming of the
web server (see page 18). The sounder beeps when pressing
the test button.
4) The multicast address is identical between the master clock
and Harmonys.
... Check that