Troubleshooting - Danby DPA120HCB1WDB Guide D'utilisation Et D'entretien

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Unit does not start when press-
ing on/off button
Not cool enough
Noisy or vibration
Gurgling sound
Power shut-off at heating mode •
DISPOSAL
Check for local regulatory compliance regarding the approved and safe disposal of this appliance.
Tel: 1-800-26-
POSSIBLE CAUSE
• P1 appears in the display
window
• Room temperature is lower
than the set temperature.
(Cooling mode)
• The windows or doors in the
room are not closed
• There are heat sources inside
the room
• Exhaust air hose is not con-
nected or blocked
• Temperature setting is too
high
• Air fi lter is blocked by dust
• The ground is not level or not
fl at enough
• The sound comes from the
fl owing of the refrigerant
inside the air conditioner
This is the automatic over
heat protection function.
When the temperature at
the air outlet exceeds 70°C /
158°F, the device will stop
15
(1-800-263-2629)
• Drain the water in the bottom
tray
• Reset the temperature
• Make sure all the windows
and doors are closed
• Remove the heat sources if
possible
• Connect the hose and make
sure it can function properly
• Decrease the set temperature
• Clean the air fi lter
• Place the unit on a fl at, level
ground if possible
• It is normal
• Switch on again after the unit
has cooled down. Reduce
temperature settings.
SOLUTION