Troubleshooting - Danby DPA080UB1GDB Guide D'utilisation Et D'entretien

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Unit does not start when press-
ing on/off button
Not cool enough
Noisy or vibration
Gurgling sound
DISPOSAL
Check for local regulatory compliance regarding the approved and safe disposal of this appliance.
Tel: 1-800-26-
POSSIBLE CAUSE
• P1 appears in the display
window
• Room temperature is lower
than the set temperature.
(Cooling mode)
• The windows or doors in the
room are not closed
• There are heat sources inside
the room
• Exhaust air hose is not con-
nected or blocked
• Temperature setting is too
high
• Air fi lter is blocked by dust
• The ground is not level or not
fl at enough
• The sound comes from the
fl owing of the refrigerant
inside the air conditioner
15
(1-800-263-2629)
• Drain the water in the bottom
tray
• Reset the temperature
• Make sure all the windows
and doors are closed
• Remove the heat sources if
possible
• Connect the hose and make
sure it can function properly
• Decrease the set temperature
• Clean the air fi lter
• Place the unit on a fl at, level
ground if possible
• It is normal
SOLUTION