Troubleshooting - Danby DPA060BACBDB Guide D'utilisation Et D'entretien

Troubleshooting

Occasionally, a minor problem may arise, and a service call may not be necessary- use this troubleshooting guide for
a possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll Free
Number for assistance.
PROBLEM
Unit does not start
when pressing on/off
button
Not cool enough
Noisy or vibration
Gurgling sound
DISPOSAL
Check for local regulatory compliance regarding the approved and safe disposal of this appliance.
ERROR CODES
E1 - room temperature sensor error
E2 - evaporator temperature sensor error
E4 - display panel communication error
P1 - water tray is full - attach drain hose and drain excess water
Tel: 1-800-26-
POSSIBLE CAUSE
• Ft appears in the display window
• Room temperature is lower than the set
temperature. (Cooling mode)
• Room temperature is higher than the set
temperature (Heat mode)
• The windows or doors in the room are not
closed
• There are heat sources inside the room
• Exhaust air hose is not connected or
blocked
• Temperature setting is too high
• Air fi lter is blocked by dust
• The ground is not level or not fl at enough
• The sound comes from the fl owing of the
refrigerant inside the air conditioner
(1-800-263-2629)
• Drain the water in the bottom tray
• Reset the temperature
• Make sure all the windows and doors
are closed
• Remove the heat sources if possible
• Connect the hose and make sure it
can function properly
• Decrease the set temperature
• Clean the air fi lter
• Place the unit on a fl at, level ground if
possible
• It is normal
14
SOLUTION