Operations
Connecting a power amplifier, subwoofer, etc.
You can connect the power amplifier, subwoofer, etc.
with analogue audio cable (not supplied) to output the
analogue audio signals.
Power amplifier,
Subwoofer, etc.
Do not input the audio signal from PRE
OUT/LINE OUT terminals to the analogue
audio input terminals of this unit. Doing so
may cause malfunction.
Using analogue audio cable
1 Disconnect the AC mains lead.
2 Connect this unit and a power
amplifier, subwoofer, etc.
3 Connect the AC mains lead to this unit.
( 13)
4 Press [AMP
] to turn this unit on.
Note
• For details, refer to the operating instructions of
the connected device.
• Sound is not output from PRE OUT terminals
when using this unit as main amplifier. ( 18)
Setting the audio output (PRE OUT)
You can set the audio output of the speaker
output terminals and PRE OUT terminals.
1 Press [AMP].
20
(20)
Analogue audio cable (not supplied)
2 Press [SETUP].
3 Press [ ], [ ] repeatedly to select
"PRE OUT" and then press [OK].
4 Press [ ], [ ] to select the output
setting and then press [OK].
• The factory default is "Off".
• Not available when using this unit as main
amplifier. ( 18)
On:
Sound is output from the speaker output
terminals and PRE OUT terminals.
On (Speaker:Off):
Sound is not output from the speaker output
terminals. Sound is output from PRE OUT
terminals.
Off:
Sound is not output from PRE OUT terminals.
Sound is output from the speaker output
terminals.
Note
• It is recommended to set to "On (Speaker:Off)"
(rated output: 1 V) when connecting a power
amplifier.
• Set to "Off" when using output correction
function for the connected speakers because
the correction function (LAPC) effects on the
audio output from PRE OUT terminal. ( 24)