Table Des Matières; Meanings Of Symbols - Tanaka TCS 40EA Instructions De Sécurité Et Mode D'emploi

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning
before use.
It is important that you read, fully
understand and observe the following
safety precautions
Careless or improper use of the unit may
cause serious or fatal injury.
Read, understand and follow all warnings
and instructions in this manual and on the
unit.
Always wear eye, head and ear protectors
when using this unit.
Warning, kickback danger. Be careful of
possible sudden and accidental upward
and/or backward motion of the guide bar.
One-handed usage not permitted. While
cutting, hold saw fi rmly with both hands
with thumb fi rmly locked around front
handle.
Chain brake
Choke
On/Start
Off /Stop
Contents
WHAT IS WHAT?................................................... 4
WARNINGS AND SAFETY INSTRUCTIONS ....... 5
SPECIFICATIONS ................................................. 7
ASSEMBLY PROCEDURES ................................. 8
OPERATING PROCEDURES ............................... 9
MAINTENANCE .................................................. 15
Parts breakdown
and warnings. Emergency stop
Fuel and oil mixture
Chain oil fi ll
Carburetor adjustment - Idle speed
Carburetor adjustment - Low speed
mixture
Carburetor adjustment - High speed
mixture
Oil pump adjustment
Priming pump
Computed kickback angle (CKA) without
a chain brake
English
3