Maintenance & Service - Evolite Evo Spot 180 Mode D'emploi

13 13
1 4 1 4
Vector Mode
15
16
 Maintenance & service
o Cleaning
The cleaning of internal must be carried out periodically to optimize light output. Cleaning frequency depends
on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause
greater accumulation of dirt on the fixture's optics.
 Clean with soft cloth using normal glass cleaning fluid.
 Always dry the parts carefully.
 Clean the external optics at least every 20 days.
o Troubleshooting
Following are a few common problems that may occur during operation. Here are some suggestions for easy
troubleshooting:

The fixture does not work, no light
o
Check the connection of power and main fuse.
o
Measure the mains voltage on the main connector.

Not responding to DMX controller
o
DMX LED should be on. If not, check DMX connectors, cables to see if link properly.
o
If the DMX LED is on and no response to the channel, check the address settings and
polarity.
o
If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
Evo Spot 180 User's Manual Ver. 1.00
0..225
226..235
236..245
246..255
0..19
20..29
30..39
40..79
80..84
85..87
88..90
91..93
94..96
97..99
100..119
120..139
140..159
160..179
180..199
200..219
220..239
240..255
Value
0..255
0..255
max to min speed
blackout by movement
blackout by all wheel changing
no function
Special function
No function
No function
Gobo Change to any position
No function
All Motor reset
Scan motor reset
Colors motor reset
Gobo motor reset
no function
Other motor reset
Internal program 1
Internal program 2
Internal program 3
Internal program 4
Internal program 5
Internal program 6
Internal program 7
Internal Sound program 1
Function
Color Time
max to min speed
Gobo Time
max to min speed
DMX
23
Page