Dmx Mode; Dmx-Protocol - Evolite Evo Spot 180 Mode D'emploi

Press the MENU key then ENTER, then use the DOWN key to reach the AUTO RUN menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
Sound Mode :
Press the MENU key then ENTER, then use the DOWN key to reach the Music Control menu. Press
ENTER and select the program from 1 to 9 then scroll down to Alone or Master, depending on
whether this unit is master or slave. Press ENTER to confirm this choice. Finally, press MENU 2 times
to return to the main menu. The device will then start its automatic program.
o DMX Mode
Each device can be individually controlled using a standard DMX-512 controller.
You must "address" each device through the "A001" menu. The filled-in address is then the base
address, address from which the device will respond.
If two devices are addressed to the same DMX address; they will then behave identically, responding
to the same DMX channels.
Wired DMX mode :
Press the MENU key and then DOWN to access the next menu. Then press ENTER then DOWN to reach
the Signal Set menu. Press ENTER and then check the DMX Cable box. Confirm this choice by pressing
ENTER.
Press the MENU key and then UP to go to the first menu. Press ENTER to select the Dmx Address menu.
Use the UP & DOWN keys to select the DMX address of the device. Press ENTER to confirm your choice.
Finally, press MENU 2 times to return to the main menu. The unit is in DMX mode, and if no DMX signal
is present, the display flashes. Then connect a DMX cable as input.
DMX mode selection via W-DMX (wireless):
In the Signal Set menu, check the WDMX & CAB box. This mode activates the W-DMX receiver. When
the devices communicate with each other, the transmitting device flashes red and the receiver (s)
flashes green.
The LED is off: no connection.
The LED flashes green quickly: the connection to the transmitter has been lost.
The LED flashes green slowly: The connection to the transmitter is established, but there is no DMX
signal.
The LED is fixed green: The connection and the DMX signal are effective.
o DMX Protocol
Mode/Channel
1 1
2 2
3 3
Evo Spot 180 User's Manual Ver. 1.00
Value
0..255
0..255
0..255
Function
Pan
PAN Movement
Pan-fine
Fine control of Pan movement
Tilt
Tilt Movement
21
Page