Connecting The System - Pioneer AVIC-F850BT Manuel D'installation

Section
02

Connecting the system

Connecting the system
The navigation unit
Wired remote input
Please refer to the instruction manual
for the Hard-wired remote control adapter (sold separately).
Note
Audio source will be set to mute or attenuate, while the following sounds will not be muted or
attenuated. For details, refer to Operation Manual.
— voice guidance of the navigation
— incoming ringtone and incoming voice of the mobile phone that is connected to this navigation
system via Bluetooth
WARNING
· To avoid the risk of accident and the potential violation of applicable laws, this product should
never be used while the vehicle is being driven except for navigation purposes. And, also rear
displays should not be in a location where it is a visible distraction to the driver.
· In some countries, the viewing of images on a display inside a vehicle even by persons other
than the driver may be illegal. Where such regulations apply they must be obeyed and this
product's video source should not be used.
8
Engb
Fuse (10 A)
Power cord
For connection, refer to the wiring and
installation manual separately supplied.
3.55 m
® wireless technology
Vehicle Bus adapter input
Please refer to the instruction
manual for the Vehicle Bus adapter
(sold separately).
13 cm
Aerial jack
RCA connector
Yellow/black
If you use an equipment with mute function,
connect that equipment to the Audio Mute lead.
If not, keep this lead free of any connections.
15 cm
GPS aerial
Vehicle aerial
4 m
Microphone