ENGLISH – Rolling screen installation and operation manual
WARNING: It 's absolutely forbidden to install the screen on mobile walls or unstable cables,the brackets must be applied on surfaces that ensure in the time your distance. When
installing the screen use plugs and screws suitable for the screen's weight and for the type of wall or ceiling on which the mount brackets are to be fixed, based on the following criteria
Screen width up to cm
Overall weight
Secure the brackets to the ceiling or wall considering a maximum distance of 5 cm from the screen's lateral edges, as shown in the picture on the left.
CEILING INSTALLATION
Proceed as described in picture 1, bring the screen close to the brackets (pos.1); block the rear part of the screen by tilting it slightly (pos.2); push the screen upwards until it
slides into the bracket (pos.3); tighten the three screws on the bracket as far as they will go (pos.4).
WALL INSTALLATION
Proceed as described in picture 2, bring the screen close to the brackets (pos.1); block the rear part of the screen by tilting it slightly (pos.2); push the screen upwards until it
slides into the bracket (pos.3); tighten the three screws on the bracket as far as they will go (pos.4).
FIG. 1
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: ALUMID Installation Manual rev3 | 29.12.2020
Please verify that you are working with the latest revision of this document before specifying your screen.
07 INSTALLATION INSTRUCTIONS
08 COUNTERWEIGHT TENSIONING ADJUSTAMENT
If the plastic cap is damaged follow the procedure below to replace the part