Rear Panel - Denon PMA-2000AE Mode D'emploi

ENGLISH
o
Input indicator
The Indicator for the program source selected with the
INPUT SELECTOR control lights.
NOTE:
When the P. DIRECT button is ON position, Input
indicator dose not light.
!0
P. DIRECT (Power amp direct) button
ON :
P. DIRECT terminals selected, and input indicator is turned
off.
OFF :
Selected INPUT SELECTOR knob makes program source
play.
NOTE:
When selecting the P. DIRECT terminal, volume control
function of this unit does not work, so set volume level
by the component connecting to this terminal.
!1
SOURCE DIRECT
• The controls (BASS , TREBLE and BALANCE ) can be
used when this switch is in the OFF (
When set to the ON (
by passed and the signals are input directly to the volume
control circuit, providing high quality sound.
!2
POWER indicator
• When the POWER switch is turned ON/STANDBY(
the power indicator lights.
Light green : Power is on
Light red : Power is in the standby mode
!3
Remote control sensor
• This sensor receives the infra-red light transmitted from
the wireless remote control unit.
• For remote control, point the wireless remote control unit
towards the sensor.

Rear panel

!4
INPUTS terminals
• These are INPUTS terminals for CD players, turntables,
AM/FM tuners, tape decks or other playback components.
NOTE:
The PHONO input terminals are equipped with a short
pin-plug. Remove this plug to connect a record player.
Store the removed short pin-plug in a safe place so as
not to lose it.
) position.
£
) position, the above controls are
¢
!5
REC. (REC OUT) terminals
• These are playing and recording output terminals for
connection to tape decks.
!6
P. DIRECT ( Power amp direct ) terminals
• Source connected to this terminal is directly fed to the
power amplifier set volume level by the component
connected to this terminal.
!7
PRE OUT terminals
• Use these when adding a power amplifier, a subwoofer
with built-in power amplifier, etc.
• Connect these PRE OUT terminals to the input terminals
on the additional power amplifier, subwoofer, etc.
NOTE:
Signals are outputted from the PRE OUT terminals
even when using headphones.
No signal is outputted when selecting P. DIRECT
terminals.
!8
SPEAKER SYSTEMS terminals
• Connect the speaker systems here.
!9
AC inlet receptacle (AC IN)
• Connect the included power supply cord here.
Do not use any other cord than the provided power supply
cord.
@0
SIGNAL GND (ground) terminal
• Connect the turntable's ground wire here.
),
¢
NOTE:
This terminal is used to reduce noise when a turntable,
etc., is connected.
It does not provide grounding.
@1
CARTRIDGE selection switch
• This switch is set according to the type of player cartridge
to be used. Set this switch to MM (
according to the type of cartridge used on your turntable.
5
ENGLISH
) or MC ( )
£ ¢