Rear Panel - Denon Professional DN-280 Guide D'utilisation

Rear Panel

1. Channel Input (unbalanced RCA): Use an RCA cable to connect an external audio source to this
input. The left and right input signals will be summed to mono.
2. Speaker Output: This output sends the main/master signal from DN-280 to your external speaker.
Connect this output to your speaker using the included Euroblock connector and speaker wire (not
included). The power of the output is less than 60 W (without distortion). See
information.
Important: Connect only one speaker type to the speaker output. Use only 70V/100V speakers designed
with step-down transformers with the 70V/100V outputs. Do not connect a low-impedance speaker (4Ω)
to the 70V/100V output terminals, as this may result in damage to your amplifier and/or speaker.
3. Vents: For proper performance, keep the vents clear from obstructions to allow air to flow.
4. Power Input: Use the included power cable to connect this input to a power outlet. Make sure DN-
280's Power Switch is set to off when connecting or disconnecting the cable.
5. Fuse: If the unit's fuse is broken, lift this tab to replace the fuse. Replace it with a fuse that has an
appropriate rating (following the specifications located on the rear panel of DN-280). Using a fuse with an
incorrect rating can damage the unit and/or fuse.
Setup
Getting Started:
1. Connect an audio source to the Channel Input, Aux Input, or Mic/Line Input.
2. Connect your speaker to the Speaker Output using the included Euroblock connector and speaker
wire (not included). See
3. Make sure that the Master knob is all the way down.
4. Connect the power cable from the Power Input to a power outlet. Then power on DN-280.
5. Adjust the Master knob to get a strong signal without distortion.
6. Adjust the Treble and Bass knobs to further control the frequencies of the sound.
Using the Euroblock Connector:
1. Use a small screwdriver to loosen the screws corresponding
to the insert ports on the Euroblock connector.
2. Twist the speaker wire to form a tight strand and insert this
into the appropriate insert port (as indicated below the
Speaker Output on DN-280). Push the wire until it is
secured inside. Repeat this step for each port.
3. Tighten the screws corresponding to the insert ports on the
Euroblock connector.
4. Insert the Euroblock connector into the Speaker Output
on DN-280.
If you would like to disconnect a wire, first make sure you
loosen the corresponding screw on the Euroblock connector
before you pull out the wire.
4
2
1
Using the Euroblock Connector
3
below for more
Screws
Insert Ports
Speaker Wire
4
5
Setup for more
details.
Speaker Output
Euroblock
Connector