Maintenance - Wolf Garten Compact plus 32 E Mode D'emploi

Cut / Collect
Activate cut/collect function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not start the motor until your feet are at a safe
distance from the cutting tool.
1. Remove the grass collecting bag.
2. Turn the switch to "CUT/COLLECT".
3. Hang up the collection bag if necessary.
4. Start the motor.
Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not attach the collection bag until your feet are at a
safe distance from the cutting tool.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
Emptying of Grassbox
When the collection bag is full, the flap lowers by itself.
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Switch off motor and pull out power plug.
Empty collection bag.
Remove potential blockages in the cutting space before
starting.

Maintenance

General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
pull out the power plug.
Do not touch running blades.
Cleaning
Clean mower thoroughly after each mowing with cloth or
brush.
Clean the mulch flap at regular intervals with a small
broom .
T
Do not spray with water.
Winter Storage
Clean mower thoroughly before storing away.
Have your mower thoroughly checked once a year by an ap-
proved Service Centre.
Do not store it in a wet or humid place.
G
Q
R
S
3
Instructions for level indicator:
For an efficient functioning of the level indicator, regularly
clean the holes under the level indicator in the collection
bag with a hand brush.
Mulch
„Mulching" is a process in which the grass is finely chopped by a
special cutting system and then deposited on the ground. The re-
sult is that the grass does not have to be collected and disposed
of. „Mulching" also prevents the lawn from drying out.
3
Instructions for mulching
We recommend:
Depending on the growth of grass, mulch 1 – 2 x per
week
The grass should not be too high nor too wet!
Go slow while mulching
Take care that the blade channels do overlap.
Do not cut grass more than 20 mm.
3
Note:
Mulching is not advisable in case of moss-affected or
entangled grass, because the cut material stays on the
moss surface and/or entanglement and thus cannot be
absorbed by the ground.
Regularly scarify and manure the lawn.
Activating the mulch function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Do not start the motor until your feet are at a safe dis-
tance from the cutting tool.
1. Remove the grass collecting bag.
2. Set the switch to „MULCH".
3. Start the motor.
Changing blades
U
For all works on blades, coupling and cutter bars, first of all,
pull out the power plug and wear protective gloves.
1
Attention!
An unbalance can develop after regrinding of the blade.
Always regrind the blades in a specialist workshop,
because an unbalance check should be undertaken
according to the safety regulations.
Always change blades in a specialist workshop. A torque
spanner of 10 mm is mandatorily required.
Fastening torque of the screws: 6 - 7 N-m
Q
U
.
15