Astralpool 58808 Manuel D'installation Et D'entretien page 3

ENGLISH___________________________________________________________________
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be implemented for
installation and start-up. Therefore, the installer as well as the user must read the instructions before beginning installation and start-up.
Keep this manual for future reference.
Disposal of waste electrical and electronic domestic systems in the European Union.
All the products marked with this symbol indicates that the product shall not be mixed or disposed with your
household waste at their end of use. It is responsibility of the user to eliminate this kind of wastes depositing them in
a recycling point adapted for the selective disposal of electrical and electronic wastes. The suitable recycling and
treatment of these wastes contributes in essential way to the preservation of the Environment and the health of the
users. For further information regarding the points of collection of this type of wastes, please contact to the dealer
where you acquired the product or to your municipal authority.
For optimum performance of the HELIOX UV MP Treatment System, we recommend you to follow the instructions given below:
1. CHECK THE CONTENTS OF THE PACK:________________________________________________________________________
You should find the following elements inside the box:
UV reactor.
Flow sensor: SI5004 + EVC005 cable (5 m. /16.4 ft.)
Temperature sensor: MBT5250 + MBTC-05 cable (5 m. /16.4 ft.)
Radiation sensor: UVC-SE + EVC059 cable (5 m. /16.4 ft..)
Automatic wiper driver + WPA-05 cable (5 m. /16.4 ft..)
Control panel.
Lamp power cables LP-035 x2 (5 m. /16.4 ft..).
Lamp power cables LP-045 x2 (5 m. /16.4 ft..).
Operation Manual.
(1)
Custom cable lengths may be supplied on demand.
2. GENERAL FEATURES: ___________________________________________________________________________________
The germicidal effects of ultraviolet light (UV) with wavelengths around 260 nm are well known for over 100 years. Its use has been
increasing in recent years as it presents a number of advantages over chemical disinfection systems, since virtually UV light no alters the
physical and chemical composition of water, it is very effective against any type of microorganism (algae , bacteria, viruses, fungi, yeasts,
etc.) further minimizing the risks of handling and dosing of potentially hazardous chemicals. Moreover, UV treatment reduces the levels of
combined chlorine in water, thereby producing significant water savings by reducing the volume and frequency of renewal of pool water.
The HELIOX UV MP treatment system in addition to maintaining a certain level of chlorine in pool water, ensure the sanitary quality of pool
water. The HELIOX UV MP treatment system will operate when the pool recirculation (pump and filter) is operational.
The HELIOX UV MP treatment systems are designed and manufactured with the latest technology in UV treatment of water, thus ensuring
continuous operation and minimal maintenance.
The proposed control architecture for the HELIOX UV MP systems has a number of features that allow the highest levels of reliability,
efficiency and scalability.

Because the systems incorporate both radiation and flow calibrated sensors, continuous adjustment of the lamp power is allowed,
thus optimizing energy consumption and lifetime. Calibrated sensors do not require any user action on them, which does not
happen with the previous range of UV systems.

Unlike the previous range, HELIOX UV MP systems manage two parameters when setting the lamp power, radiation measured by
the sensor and flow. Thus, the system sets a nominal radiation for each model, which is determined by the maximum treatment
flow to ensure a minimum disinfection efficiency. If the flow to be treated is less than nominal, so too will be the radiation needed,
so the systems will decrease the lamp output power, optimizing energy consumption and increasing lamp lifetime. Like the
previous range, whether radiation decreases due to loss of lamp efficiency, turbidity, etc., the system will adjust the lamp power.

The lamp power system is based on an electronic ballast which allows continuous operation with high efficiency (greater than
95%).
(1)
.
(1)
; or TM 4411+ EVC005 cable (5 m. /16.4 ft.)
(1)
(1)
(x2 in case of MP-450W model).
(1)
(in MP 50W ... MP 300W models).
(1)
(in MP 450W model).
1
(1)
.