Astralpool 58808 Manuel D'installation Et D'entretien page 23

6.6. Diagnostics of the UV lamp(s) power circuit(s).
Pressing the "Diagnostics" key, the system accesses a diagnostic screen both of the electronic ballast and the power
circuit of the UV lamp.
This screen provides a very detailed information about the operation of the electronic ballast, so that in case of
malfunction or breakdown it is very easy to locate the cause thereof.
The navigation keys located on the top of the screen allow access to various diagnostic and configuration screens.
Whenever there is an alarm in the electronic ballast, it will be locked until you press the "RESET" button.
INACTIVATION OF ONE OF THE POWER CIRCUITS OF THE LAMPS IN MULTIPLE LAMP SYSTEMS
In multiple lamp systems (MP 450W) it is possible to cancel one of the power circuits of the lamps if for any reason, it
was necessary (eg, leaving the system in service pending replacement of a lamp, etc.). To do this, simply enter in the
diagnostic screen of the corresponding lamp and press on the icon. When the power circuit is disabled, the icon will
flash in yellow. To activate the circuit again, just click on the icon. It will return to normal state in green colour.
If you press the button located
at the top of the menu to
access the alarm log, you can
view all alarms detected by the
system from its connection.
To exit, simply press the arrow
keys located at the top of the
screen.
21