Controls And Indicators - Astralpool 58808 Manuel D'installation Et D'entretien

5.8. Installation of the WPA-1 electric wiper driver
HELIOX UV MP systems equipped with automatic cleaning system of the quartz sleeve, have a rotary electric driver that activates the wiper
mechanism at programmable time intervals in the control panel of the unit. The WPA-1 driver has an IP 54 plastic enclosure. All the engine
and gearbox bearings are permanently lubricated. The WPA-1 driver has a mechanism that also allows to drive the wiper manually.
The WPA-1 driver is supplied fully assembled from factory so it is not necessary to perform any operation on it.
Connect the WPA-1 driver with the WPA-05 cable supplied with the unit to the corresponding terminals at the terminal block inside the control
box. (see page 8-9).
Warning
When powered, the driver may cause the wiper shaft to move without further notice. Never
place elements that could block the path of the driver lever as the wiper cycle can start
automatically without warning.

5.9. Controls and indicators

The HELIOX UV MP treatment systems are equipped with a touchscreen located on the front of the control panel, which includes an
advanced software that allows full control both on the treatment process and on the power of the UV lamp. Also on the front panel it is the
main switch of the system.
15