Honsel RivSmart eBZ ZERO S Manuel D'utilisation D'origine page 42

The warning message "Tool Overload" indicates
that the RivSmart is being overloaded.
Acknowledge the error message by pressing the
"OK key" (T).
The reason for this can be a rivet with a shear
load of over 8500 N or mechanical problems in
the RivSmart. Should this fault occur again when
setting rivets below 8500 N, check whether the
clamping mechanism needs to be cleaned.
If problems continue to occur, the RivSmart should
be sent to a service centre for inspection.
The warning message "Battery Cell Low Voltage"
indicates that the battery cell on the power elec-
tronics is empty.
Acknowledge the error message by pressing the
"OK key".
Send the RivSmart to a service centre for mainte-
nance. If the battery cell is not replaced, the time
will not be stored in the RivSmart and a reliable
correlation to the process stamps is not possible.
The warning message "Battery Empty" indicates
that the battery is empty.
Acknowledge the error message by pressing the
"OK key" (T).
Replace the empty battery with a fully charged
battery.
42 | English