Honsel RivSmart eBZ ZERO S Manuel D'utilisation D'origine page 32

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• Attention: Ensure that the mains plug fits in your
plug socket. Do not use force.
• When the charger has been connected to the
mains power supply, the LEDs of the charger
light up green and white.
• Now push the battery onto the charger from the
rear. LED 2 now changes from white to flashing
RED.
• When the LEDs have a steady GREEN and RED
light, you can take the battery from the charger.
• Charge only Rivdom PLUS batteries (F).
• Charge only in a temperature range between 0
and 40 °C.
STUD HOLDER
The RivSmart (P) is equipped with a safety switch,
the "stud holder", and thus conforms also to the
Machinery Directive. This prevents the riveter being
used without stud collector (E). Never operate the
riveter without stud collector (E) or stud secur-
ing cap (J). Never bypass the safety switch. The
stud collector (E) must be completely screwed
on before the riveter can be put into operation. If
this is not the case, the trigger is blocked and a
warning sounds and an error message appears on
the OLED display. If you have to work in confined
spaces, the stud securing cap (J) can be fitted
instead of the stud collector (E). When working
with stud securing cap (J), hold the riveter with
the mouthpiece (A) facing downwards after each
set rivet to ensure that the sheared mandrel drops
out of the riveter to the front. Do not use fixed or
retainer mouthpieces (A) together with the stud
securing cap (J). This would result in damage to
the riveter (P)!
BELT CLIP
Attach the belt clip (O) to the foot of the riveter (P)
using the screw (M). A corresponding thread and
two slots (L) are recessed in the foot of the housing
on both sides of the riveter (P). Check at regular
intervals that the clip (O) is still securely attached,
otherwise retighten the screw (M).
RIVET APPLICATION PLATE
In order to allocate the riveter (P) to a department,
a product or a rivet, write the details on the rivet
application plate (N) and attach the plate to the
riveter (P).
32 | English
SCREW ON STUD COLLECTOR
The stud collector (E) must be completely screwed
on before the riveter (P) can be put into operation.
If this is not the case, the trigger (I) is blocked and
a warning sounds and an error message appears
on the OLED display (S). Screw on the stud collec-
tor (E) supplied!
INSERT BATTERY
When the battery (F) has been charged, push it
onto the foot of the riveter from the front. After a
few seconds, the following message appears on
the OLED display (S):
PREPARE MOUTHPIECE
The right mouthpiece (A) is needed for every rivet.
The scope of delivery includes three mouthpieces
(A) for standard rivets with the rivet shaft diame-
ters 2.4, 3.0/3.2, 4.0 mm. Should the appropriate
mouthpiece (A) not be in the scope of delivery, it
can be ordered from HONSEL or your local dealer.
No tools are required to change the mouthpiece:
• Press the trigger (I) and hold it depressed.
• Unscrew the mouthpiece (A) by hand.
• Screw on the appropriate mouthpiece (A)
finger-tight.
• Release the trigger (I) again.

Publicité

Table des Matières
loading

Table des Matières