Wireless Operation - Chauvet Professional Well Fit Guide De Référence Rapide

WELL Fit QRG
Wireless
Operation
Initial Setup
Configuration
Product Pairing
Storage Notes
In optimal conditions, the WELL Fit can operate up to 300 m (900 ft) away from
the W-DMX transmitter. The W-DMX receiver in the WELL Fit must be paired
with the W-DMX transmitter for wireless operation.
1. Turn the W-DMX transmitter on.
2. Connect the W-DMX transmitter to a DMX controller.
3. Place the WELL Fit within 300 m from the W-DMX transmitter.
4. Disconnect any DMX cable from the WELL Fit.
5. Turn the WELL Fit on.
1. From the WELL Fit's control panel, go to DMX Address.
2. Select the start address, as with any other DMX compatible product.
3. Go to Wireless Setting > Receive.
4. Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5. Press the reset button on the W-DMX transmitter.
(The Signal Strength Indicator on the WELL Fit will show a
ϟ in front of the bars for 3 seconds while a connection is established.)
If the WELL Fit has already been paired with the W-DMX transmitter, the Signal
Strength Indicator in the middle of the LCD screen will show the strength of the
signal. In this case, the WELL Fit is ready to work in Wireless mode.
Pairing the WELL Fit and a new W-DMX transmitter
1. From the WELL Fit's control panel, go to Wireless Setting.
2. Select Reset. The Signal Strength Indicator on the WELL Fit will show a ? in
front of the bars.
3. From the W-DMX transmitter, press <RESET> (the Signal Indicator on the
transmitter will flash).
4. Once the transmitter has found the WELL Fit, the Signal indicator on the W-
DMX transmitter will illuminate solid.
5. The Signal Strength Indicator in the middle of the LCD screen on the WELL
Fit will show the strength of the signal.
· Always store the product in an upright position (≤ 10° tilt).
·
Recharge the battery to full capacity before storing the product.
·
Store charged product(s) in a dry environment, away from direct sunlight.
W-DMX operation can be interrupted or inhibited by liquid masses between
the transmitter and receiver such as water, snow, or people. For best results,
keep the area between the transmitter and receiver clear of any liquid mass.
4
EN