Setting Remote Control Codes That Are Not Stored In The Remote - Sony STR-DA3300ES Mode D'emploi

Starting macro play
1
Press AMP.
The AMP button lights up, and then turns
off.
2
Press MACRO 1 or MACRO 2 to start
the macro.
The macro starts and execute the
commands in the order you assigned them.
While the commands are being sent, the
RM SET UP button flashes and the AMP
button lights up. When the commands have
been sent, the RM SET UP and AMP
buttons turn off.
To erase a programmed macro
1
Press MACRO 1 or MACRO 2 for more
than 1 second while pressing RM SET
UP to clear the stored macro.
The RM SET UP button flashes,
repeatedly.
2
Press RM SET UP.
Settings stored as macro are cleared.
124
GB
Setting remote control
codes that are not stored
in the remote
Even if a remote control code is not one of the
presets stored in the remote, it is possible for
the remote to learn the code using the learning
function.
Note
When setting up the receiver to learn the remote
command modes, replace the batteries with new
ones.
1,6
1
2
Example for assigning numeric button 1 to
VIDEO 1 of the remote:
1
Press TV while pressing RM
SET UP.
The RM SET UP button lights up.
Tip
When you press RM SET UP, use a thin wire,
such as a paper clip.
2
Press the input button (VIDEO 1
in the example) for which you
want to use the Learning input
function.
The input button flashes. (The RM SET
UP button remains lit.)