Preparation 1: Preparing The Receiver And The Remote Control - Sony STR-ZA5000ES Mode D'emploi

Preparation 1: Preparing the receiver and
the remote control
Before starting the following steps, connect speakers and AV
devices to the receiver referring to the supplied Startup Guide.
1
Insert batteries into the remote control with correct polarity.
R03 (size-AAA) batteries
2
Connect the supplied AC power cord (mains lead) to the AC IN
terminal on the receiver firmly, then connect the AC power
cord (mains lead) to a wall outlet.
AC power cord
(mains lead)
(supplied)
*
AC IN terminal
To the wall outlet
* Space remains between the plug and the rear panel even when
the power cord (mains lead) is inserted firmly. The cord is
supposed be connected this way. This is not malfunction.
3
Press  to turn the AV receiver on.
4
Place the optimizer microphone at your listening position and
set it at the same height as your ears.
The optimizer microphone is used for setting the speakers (Auto
Calibration) in Preparation 2 (Easy Setup).
Perform this step after removing the front cover.
Note
Fully insert the plug of the optimizer microphone into the AUTO CAL
MIC jack.
5
Turn the TV on, and then switch the input of the TV to which
the receiver is connected.
13
US