Safety Instructions - Josef Kihlberg 561-15PN Mode D'emploi

Josef Kihlberg 561-15PN
KUDA PACKAGING
3
6 8 10
4 12
2 14
0 16
SERVIS A NAHRADNÍ DÍLY
4
www.kuda-packaging.com

SAFETY INSTRUCTIONS

Inform yourself!
Read the operating
instructions carefully.
Protect yourself!
When operating the
stapler, wear eye, ear
.
protection
Warning: Danger of
crushing!
Do not put your fingers
underneath the nozzle.
Warning:
Hazard!
Lay the compressed air
hose so that there is no
risk of tripping over it.
Do not exceed the air
pressure!
Do not exceed the re-
commended air pressure.
Use safety coupling!
For connecting the air
hose to the stapler, use
only a safety coupling.
Do not use a bottled air
or gas source!
Do not operate this stap-
ler by using a bottled air
or gas source.
Never leave a loaded
tool unattended!
Always disconnect the
tool from air supply when
not in use.
+420 607 237 237
info@kuda-packaging.com
Original
KIHLBERG
Use for the intended purpose
The top stapler is intended for stapling of card board.
This stapler was designed and manufactured for safe
handling during the stapling operation.
Possible misuse
Do not fire any staples into the air or use the stapler
with any other materials than mentioned above.
Servicing
The following maintenance work must be carried out
at regular intervals, varying with working conditions
and workload:
– daily check of compressed air pressure
5.0–6.0 bar (73–87 psi).
– clean the stapler regularly.
– check the condition of the stapler at regular inter-
vals for defects or worn parts. Never use a stapler
that has defective or worn parts (for servicing tasks
refer also to chapter 7.1 until 7.3).
servis@josef-kihlberg.eu
Original
JOSEF KIHLBERG
staples must be used
exclusively!
Original
JOSEF KIHLBERG
spare parts must be
used exclusively!
Not using original spare
parts will dissolve the
warranty and the liability.
06.14