Table des Matières
Publicité
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - handshower
Flow rate - spout
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• This trim is for use with rough valve 13444181.
• The mounting surface must be finished and made
watertight before installation of this trim kit.
• Protection against backflow is provided by a
check valve in the handshower hose and by an
automatically resetting diverter.
• This handshower is for use with automatic
compensating valves rated at 1.5 GPM (5.7 L/min.)
or less.
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.0 GPM max.
approx. 6.6 GPM @ 44 PSI
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or other
approved anti-scald device.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve must be no
higher than 120°F. In Massachusetts, the maximum
output temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
Table des Matières
