Star Progetti HELIOSA HI DESIGN 66 Série Mode D'emploi page 14

REPLACEMENT OF BULB
HELIOSA HI DESIGN 66 IPX5
2. REMOVE THE TWO SIDE COVERS AND THE TWO
LATERAL REFLECTOR TERMINAL HEAD COMPONENTS.
4. REMOVE THE 2 BULB EXTREMITY HEAT-ELASTIC CAPS
AND DISCONNECT THE TWO FASTONS CONNECTING THE
CORDS TO THE BULB (IF THE CAPS USED DISPLAY SIGNS OF
DRYING, THESE MUST BE REMOVED BY CUTTING THE
CORDS NEXT TO THE TWO FASTONS).
6. CONNECT THE MALE FASTONS OF THE NEW BULB TO
THOSE OF THE TWO CORDS. COVER THEM WITH THE HEAT-
ELASTIC CAPS AND RE-POSITION THE BULB IN THE SEAT OF
THE SPRING CLIPS.
2
4
14
1. UNSCREW THE 4 SCREWS ON THE BACK.
3. RELEASE THE BULB FROM THE CLAMPS.
5. APPLY THE SPARE HEAT-ELASTIC CAPS TO REPLACE
THOSE WHICH HAVE BEEN REMOVED. STRIP THE CORDS
(5-6 mm). APPLY THE NEW SPARE FASTONS AND PRESS
THEM ONTO THE STRIPPED PORTION OF THE CORDS. DO
NOT TOUCH THE BULB WITH YOUR BARE HANDS.
7.REASSEMBLE THE DEVICE BY PERFORMING THE ABOVE TASKS
IN REVERSE ORDER.
1
3
5