Installation; Laying The Cables - Abus TVIP91 Série Mode D'emploi

6. Installation

Instructions for how to mount the camera are described in the quickstart guide for the relevant IP
camera TVIP9XXXX.
When mounting the dome cameras TVIP91700 and TVIP92700 please make sure
that the desiccant bag supplied is placed inside the camera before placing on the
dome. The bag must be placed close to the base plate. The bag must not be in the
field of view of the lens. The bag must not be placed directly behind the lens or the
camera board.
6.2

Laying the cables

You must pay attention to the following instructions when laying the cables:
TVIP91100/TVIP92100
A break-out panel for feeding the cable is located on the base plate for laying the cables at the
side. Use pliers to remove the break-out panel. Use a file to smooth out the edges of the break-
out panel.
TVIP91300/TVIP92300
A break-out panel for feeding the cable is provided for laying the cables at the side. Use a flat,
narrow screwdriver to remove the break-out panel from the plastic.
These cameras are equipped ex works with a short connecting cable for networking
(RJ45), power supply (barrel connector) and analogue video output. Making the
connection is possible from inside the camera. In the most simple case, a network
cable with Power over Ethernet power supply is all that's needed to operate the
camera.
If the functions switching input, switching output or audio input/output (TVIP92300
only) are needed, you must install an extended connecting cable (for TVIP91300:
TVAC40700; for TVIP92300: TVAC40720).
TVIP92500
When laying the cable, ensure that none of the plug connections is subject to mechanical tension.
Furthermore, cables must be fixed in such a way as to prevent the plug from being bent or
snapped off.
TVIP91600/TVIP92600 / TVIP92610
A break-out panel for feeding the cable is located on the base plate for laying the cables at the
side. Use pliers to remove the break-out panel. Use a file to smooth out the edges of the break-
out panel.
74