Network Loss Recording - Abus TVIP91 Série Mode D'emploi

10.4.1.7 Network loss recording

This function allows you to record video data to your internal camera memory in case of IP
network failure. Despite the recording device losing its connection to the network, the video data
remains available in the camera for this period.
As the function tests the existence of a certain IP address or domain address in the network, it
can also be considered "recording when the network device fails". That means that the camera
can record internally if another camera fails. This function is useful where both cameras have the
same or a similar field of view.
Enable network loss recording:
Cycle recording:
Ping IP address:
Interval:
If the camera has the function "Record during network failure" and this function
is to be used, it's necessary to supply the camera via the 12 V DC terminal (do
not use PoE).
activates the function
if activated, old data is deleted when the internal memory
reaches its maximum capacity so that new data can be
stored.
IP address or domain address that is tested for existence in
the network (this could be the NVR, for example)
interval for the test. The ping interval determines when
recording starts after the unsuccessful ping. The smaller the
interval, the earlier the recording is able to begin (but this
does require a good network infrastructure).
100