Switching On - Pelgrim GVW430RVS Mode D'emploi

OPERATION

Switching on

EN 8
• Open the door to the dishwasher.
• Press the "on/off" button (1) to switch on the appliance.
The indicator will light up when the appliance is switched on.
• Select the desired cycle (see page 10 "cycle selection table").
Press the programming button (2) repeatedly to select the required
cycle. The indicator (7) corresponding to the selected cycle will light up.
• Press the 'Start/Pause' button (5). The dishwasher will automatically start
running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (3). You can choose to delay the start time by
3, 6 or 9 hours. The indicator (8) corresponding to the selected delayed
start time will light up.
Select half load
The dishwasher with Half Load Washing Function adapt to your needs,
so you can save energy consumption, water consumption as well as
cycle duration by loading dishes of half capacity anywhere you prefer.
Stopping or changing a wash cycle
Press the 'on/off' button (1) to switch off the appliance. Press and hold the
programming button (2) for more than 3 seconds. Press the 'on/off' button
(1) again to switch on the appliance. You can now re-select the desired
cycle (see page 10 'cycle selection table).
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Detergent
compartment).