Switching On - Pelgrim GVW460ONY Mode D'emploi

OPERATION

Switching on

EN 8
2 6 3
2 6 3 7
• Open the door to the dishwasher.
• Press the "on/off" button (1) to switch on the appliance.
The indicator will light up when the appliance is switched on.
• Select the desired cycle (see page 10 "cycle selection table"). Press
the programming button (5) repeatedly to select the required cycle.
The indicator (4) corresponding to the selected cycle will light up.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (6). You can choose to delay the start time by
3, 6, 9 or 12 hours. Each press of the button (6) changes the delay time.
The indicators (6) show the delayed start time that has been selected.
Select half load (only model GVW475ONY)
The dishwasher with Half Load Washing Function adapt to your needs,
so you can save energy consumption, water consumption as well as
cycle duration by loading dishes of half capacity anywhere you prefer.
Selecting the "3-in-1" function
The dishwasher features a 3-in-1 function. If you select this function
(button 6), the dishwasher does not need to be filled with salt and rinse
agent, but rather you use so-called 3-in-1 dishwasher tablets in their place.
This function only applies to 3 cycles: Intensive/Normal/ECO.
Note: Only use 3-in-1 tablets in combination with the 3-in-1 wash cycle. If
you use 3-in-1 tablets with other cycles, this will deliver lower performance
in terms of the washing results.
GVW460ONY
4
5
GVW475ONY
4
5