Switching On - Pelgrim GVW426RVS Mode D'emploi

OPERATION

Switching on

GB 8
8
3 4
2
2h 4 h 6h 8h
7
1
• Open the door to the dishwasher.
• Press the "on/off" button (1) to switch on the appliance.
The indicator (2) will light up when the machine is switched on.
• Select the desired cycle (see page 10 "cycle selection table").
Press one of the programming buttons (6) repeatedly to select the
required cycle. The indicator (5) corresponding to the selected cycle
will light up.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (7). You can choose to delay the start time by
3, 4, 6 or 8 hours. Each press of the button (7) changes the delay time.
The indicators (8) show the delayed start time that has been selected.
Stopping or changing a wash cycle
Open the door. Press and hold the programming button (6) on the
selected cycle for more than 3 seconds. You can now re-select the
desired cycle (see page 10 "cycle selection table). Now close the door.
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
5
6