Perel FT10CN Mode D'emploi page 9

Troubleshooting
The fan does not work.
The piezo igniter does not
work.
No gas on the burner.
Gas leak and/or gas smell.
The burner switches on but
the flame dies out when
releasing the gas valve
button.
Too much incoming gas or too
large a flame.
The burner dies out.
V. 01 – 20/06/2019
FT10CN/FT15CN/FT30CN
problem
No power voltage.
The fan is locked.
Damaged power cable of
switch.
The electrode is in the wrong
position (distance to the
burner is too large or too
small).
The gas valve is closed.
The gas cylinder is empty.
Gas connections badly sealed.
Gas connections badly sealed.
The thermo-element is
insufficiently warmed up or
damaged.
Damaged pressure regulator.
Insufficient air feeding.
The heater is overheated.
Insufficient gas feeding
volume (empty tank).
possible cause
9
possible solution
Check if the heater is
connected to the mains and
the residual-current device or
fuse switch is fine.
Please contact a technician.
Please contact a technician.
Please contact a technician.
Open the gas valve.
Replace the gas cylinder as
described in chapter
Connecting and Replacing
the Gas Cylinder.
Close the gas supply
immediately and contact a
technician.
Close the gas supply
immediately and contact a
technician.
Re-ignite and press the gas
valve button for at least
30 seconds after ignition.
Please contact a technician
with recurring problems.
Replace the pressure
regulator.
Make sure the fan works
perfectly. Assure optimum
airflow by removing all
objects in front of the air
intake and outtake. Respect
the prescribed safety
distances:
- Air intake > 2.5 m
- Air outtake > 3.5 m
- Sides > 2 m
- Above heater > 2 m
Leave the heater to cool down
for 5 minutes before
switching on. Please contact a
technician with recurring
problems.
Check the gas feeding volume
and connect a new/bigger gas
cylinder if necessary as
described in chapter
Connecting and Replacing
the Gas Cylinder.
©Velleman nv