Connecting To The Mains - Perel FT10CN Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.

Connecting to the Mains

Before connecting the heater to the mains, check if the used power supply and frequency
match the specifications on the specification tag. Always respect the local regulations when
connecting the heater to the mains.
Only connect the device to an earthed mains.
Disconnect the device from the mains prior to any maintenance or cleaning activity.
Always make sure that the mains is earthed.
7.
Switching On the Heater
1. Open the gas valve.
2. Flick the switch to position I.
3. Fully press and hold the gas valve. Operate the ignition several times.
4. The flame burns. Hold the gas valve pressed for 15 seconds to activate the safety
mechanism.
5. Release the gas valve. The flame will keep burning.
The safety mechanism will automatically switch off the heater in a few seconds in case of
an electric power failure. This mechanism will also switch off the heater in case of a gas
shortage. In both cases, follow the explanation above to switch on the heater again.
6. Regulate the gas flow.
7. Avoid operating the ignition for a prolonged period. Check for problems if the heater does
not switch on.
8.
Checking a Switched-On Heater
Check a switched-on heater by observing the pilot flame at the air exit of the heater. Make
sure that the pilot light burns steadily inside the burner.
Be careful when checking the pilot light as the air exiting the heater can be extremely hot.
Maintain yourself at a safe distance.
9.
Switching Off the Heater
1. Close the gas cylinder.
2. Close the pressure regulator or disconnect it from the gas cylinder.
3. Leave the heater to cool down for at least 60 seconds after the pilot light has died out.
4. Switch off the heater by flicking the switch to the O position.
5. Disconnect from the mains by pulling the plug.
6. Disconnect the flexible hose from the heater.
V. 01 – 20/06/2019
FT10CN/FT15CN/FT30CN
7
©Velleman nv

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ft15cnFt30cn

Table des Matières