Perel FT10CN Mode D'emploi page 8

10. Using the Heater near Persons or Animals
The heater can be used in a well-ventilated room where the pollutant percentage does not
exceed the allowed levels.
Sufficient ventilation is guaranteed only when the minimum room volume, in m³, is 30 times
the nominal thermal power (in kW) of all the switched-on devices used in that room, and when
the ventilation happens through doors, windows or other openings which have a minimum total
volume, in m³, of 0.003 times the nominal thermal power (in kW) of all the switched-on
devices used in that room.
Do not use the heater to permanently heat stables or other animal housings.
11. Using the Heater far from Persons and Animals
This heater may only be used for heating rooms if the necessary airflow needed for the burning
of the fuel can be guaranteed.
The necessary air volume is guaranteed when the minimum room volume, in m³, is 10 times
the nominal thermal power (in kW) of all the switched-on devices used in that room.
A normal airflow through doors and windows must be guaranteed.
12. Ventilation during the Summer
This heater can also be used as a fan. To do so, disconnect the heater from the gas source,
connect to the mains and flick the switch on the I position.
Follow the correct procedure and disconnect the heater from the mains if it has previously been
used in heating mode. See chapter Switching Off the Heater.
13. Cleaning and Maintenance Instructions Intended for the User
Any cleaning activity involving a dangerous component (e.g. replacement of a damaged power
cable, repair of the burner) must be done by the manufacturer, its after-sales service or a
qualified technician in order to avoid risks, even if the device has been disconnected from the
mains.
Clean the heater after each use and prior to storing the device.
Regularly clean the burner when using the heater in dusty environments.
Check the flexible gas hose and the mains connection prior to using the heater. Contact a
specialised technician if in doubt about the quality of the gas hose.
Never clean a switched-on heater.
Completely disconnect the heater from the mains before any cleaning activity. See chapter
Switching Off the Heater.
Cleaning the heater does not require special tools. Always check for gas leaks in the circuit or
at the connections, and make sure the pressure is correct after and before each cleaning
activity.
Maintenance should be performed at least once a year.
Any repair activity must be performed by qualified personnel only. Never open the appliance
yourself!
Disconnect the gas hose and store the appliance in a dry, clean, dust-free and safe place
outside the reach of children.
Always close the stop valve of the gas cylinder first when the appliance is not in use.
Use with cylinders of approximately Ø 30 cm, H 55 cm.
Only use a gas hose in accordance with EN 16436-1:2014+A1 class 2 with a diameter of min.
6.3 mm and a recommended length of 1.5 m.
Only use this appliance together with an EN 16129 compliant regulator (G31:700 mbar).
V. 01 – 20/06/2019
FT10CN/FT15CN/FT30CN
8 ©Velleman nv