Dishwasher Feedback Section; Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started - KENMORE ELITE ULTRACLEAN 665.1474 Série Guide D'utilisation Et D'entretien

Indicator Lights
Selecting Cycles and Options
1. To repeat the same cycle/options used on previous cycle, press START/RESUME once to show which selections you used. Press
START/RESUME again and close the door within 3 seconds to run the cycle. If the door is not closed in time the dishwasher will
beep several times and will not start.
2. To start a new cycle, select the desired options, then press START/RESUME and close the door within 3 seconds to run the
cycle. If the door is not closed in time the dishwasher will beep several times and will not start. Not all options are available for
every cycle. If an invalid option is selected for a given cycle, the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP for 3 seconds to toggle sound On and Off. The sound will not deactivate for cycle interruption or
service required messages.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press and hold the CANCEL/DRAIN button until the Cancel/Drain light turns on.
3. Close the door. The dishwasher starts a drain cycle if water remains in bottom of dishwasher. Let the dishwasher drain completely.
The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. If the Add a Dish indicator is lit you may add items to the load.
3. Press START/REESUME.
4. Press and hold CANCEL/DRAIN twice to reset the control.
5. Select new cycles and options.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. If the Add a Dish indicator is lit you may add items to the load.
3. Press START/RESUME.
4. Close the door. The door must be closed within 3 seconds of pressing Start/Resume, or the dishwasher will beep several times and
the cycle will not resume.

Dishwasher Feedback Section

The indicators will inform you if you are able to add a dish to the cycle after it has started.
They will inform you if the dishwasher cycle is running or complete and sanitized. They will
also inform you if the control is locked.

Canceling A Cycle

Changing A Cycle After Dishwasher Is Started

Adding A Dish After Dishwasher Is Started

19