Button Sewing - Brother XL-5130 Manuel D'instructions

49

Button Sewing

Pattern Stitch Length
(Zigzag Stitch)
1. Measure the distance between the holes and set the appropriate
stitch width with the stitch width dial. For example, if the distance
between the holes is 1.5 mm (1/16"), set the stitch width to "1.5".
2. Attach the button sewing foot.
3. Place the darning plate on the needle plate.
(When the machine is equipped with a drop feed lever, lower the
feed dogs by setting the drop feed lever to the up position.)
4. Place a button between the foot and the fabric and make sure that
the needle enters the holes without hitting the button. If it hits, see
step 1.
5. At a slow speed, sew approximately 10 stitches.
6. Remove the material from the machine. Cut the upper and lower
threads and tie the two threads at the back of the fabric.
Stitch Width Foot
Button
Any
Sewing Foot